Then turn the unit on-if the problem persists, try the Litter-Robot 3 Troubleshooter or contact Whisker Support. Reassemble the unit and verify a proper litter level. Turn the unit off and remove the bonnet and globe. Flashing yellow to red means the motor has detected an obstruction or jam.If your Litter-Robot 3 troubleshooting is more complex than the scenarios described above, you’ll likely notice lights flashing sequentially: Litter-Robot 3 lights flashing sequentially Have a Connect? You can also turn 8-hour sleep mode off or on in the Whisker app. (The unit will not cycle automatically during those 8 hours.) If you’d like to deactivate sleep mode, press and hold the Cycle button for 5 seconds. If both the blue and yellow lights are illuminated on your Litter-Robot 3, it means that the unit is in 8-hour sleep mode. This will often resolve an issue of too much weight in the globe. Depending on the litter you're using, you can remove some litter to be a little below the raised fill line. Then hit the Reset button to reset the cat sensor. Litter should not surpass the raised fill line on the black rubber liner inside the globe. Make sure your cat has left the unit, then check for excess weight, such as too much litter or waste. The unit is counting down to a clean cycle, depending on your set wait time (3, 7, or 15 minutes).Ī flashing red light indicates that the cat sensor has been activated continuously for 2 minutes or more by either too much weight in the unit or your cat not leaving the unit. Then turn the unit back on and hit the Reset button.Ī solid red light on your Litter-Robot 3 control panel means that the cat sensor was activated by your cat entering the globe while the unit was ready for use. In this case, you will need to turn the Litter-Robot off and check the waste port in the base to remove any obstruction. Flashing yellow quicklyįlashing quickly (about four times per second) means the anti-pinch safety feature detected a pinch condition. Last but not least, check for excess weight, such as too much litter or waste.The unit will resume cycling 5 seconds after the bonnet is replaced. Check that the bonnet tabs at the side and rear are secured to the base. A slowly flashing yellow light may also mean that the bonnet is removed or disconnected. It will resume cycling 15 seconds after the cat leaves the globe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |